[Shotimes] Dash Support Brace

[David P]

Pull out the center console and you will see some steel brackets that are
attached to the steel frame of the dash underneath the radio/coin tray area.
Run a piece of angle iron from there to the floor, and put some kind of hard
rubber foot between it on the floor. Do this after tightening the
screws/bolts that hold the top of the dash to the firewall. Make sure the
angle iron piece pushes up just slightly on the dash. No more shaking for
you, my friend.



David P

95MTX



~
----- Original Message -----
From: "Christian Kesselring" <ckesselring@sisna.com>
To: "Shotimes" <shotimes@autox.team.net>
Sent: Monday, November 18, 2002 13:47
Subject: [Shotimes] Dash Support Brace


> What I am thinking I would like to do is cut a 1" dowel to a length that I
> can jam up against the underside of the dashboard.  As it is, my 92 sounds
> like it is about to disintegrate all over the freeway at speeds of ~75mph.
> I know, I know...wheel/tire balance issue, but until I get that taken care
> of, I want to be able to hear myself think on the freeway.  Has anyone
done
> this, and what did you use?  What is a good length?  TIA