[Shotimes] 02 Sensor Wiring Question

[Ron DeReus]

I did that last year.  Can't say I remember anything beyond the fact that
you need a torch - a lighter isn't going to cut it; and my old ones tested
bad, so I replaced them both, but now I wish I had also tested the new ones
before putting them on to make sure the testing was valid.  I never had a
check engine light at the time, but she was acting funny.  Later on I got
the light, and it turned out to be the camshaft id sensor.

Ron DeReus
95MTX

-----Original Message-----
From: shotimes-admin@autox.team.net
[mailto:shotimes-admin@autox.team.net]On Behalf Of Josh Salaets
Sent: Friday, April 18, 2003 12:46 PM
To: SHOtimes
Subject: [Shotimes] 02 Sensor Wiring Question


Hey Everyone,

I am going to be bench testing some 02 sensors using the procedure on
SHOtimes
outlined at the link below:

    http://makeashorterlink.com/?O54E25244

I was curious if anyone knows how to determine which wires are which,
specifically which one is the output wire.  I also wouldn't mind knowing
what
the other wires were.

Thanks in advance!

Josh Salaets
95 SHO MTX (See it at: www.cardomain.com/id/sh0gun)
85 Omni GLH-T (Yeah, it's fast)
NWSHOC Member
Eugene, OR
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes