[Shotimes] rod bearings

[Paul L Fisher]

www.kurtmetros.com is how I did mine. It took approximately 8 hours of
actual wrench time for me.

What tranny? MTX or ATX? MTX is easier since the oil pan bolts are easier to
get to.

Let me know if you have any specific questions after you read Kurt's site.
Where are you located?

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 171K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back, Holley
190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar, Performance-Plus
Stainless Steel Y-pipe, '96 brake upgrade, Proportioning valve plugs, Delrin
sub-frame bushings, Amsoil Series 2000 0W-30 oil, Amsoil Synthetic ATF.

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm

Get $5 free from Paypal! https://www.paypal.com/refer/pal=P3XEFFBFUFKN6

----- Original Message ----- 
From: "Kerry Kinion" <kerry@kinionfurniture.com>
To: <Shotimes@autox.team.net>
Sent: Monday, April 28, 2003 1:44 PM
Subject: [Shotimes] rod bearings


> Hi All,
>
> Well, I hooked up with Josh S. this weekend and thinks the ticking noise
> is rod bearings.  Question is:  Is there any links to step by step
> instructions (w/pictures ideally) for replacing rod bearings?  I
> couldn't find anything on ShoTimes.
>
> Thanks!
>
> Kerry
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.476 / Virus Database: 273 - Release Date: 4/24/2003