[Shotimes] Air intake couplers, anyone know of a good place?

[Paul Nimz]

The Fernco 3" rubber plumbing connector or 3" elbow will work just fine.

Paul Nimz
'97 TR SHO
'93 EG mtx SHO


----- Original Message ----- 
From: "Bruce Malachuk" <bmalach1@nycap.rr.com>
To: "SHOtimes" <shotimes@autox.team.net>
Sent: Tuesday, April 29, 2003 10:13 PM
Subject: [Shotimes] Air intake couplers, anyone know of a good place?


> I'm in the process of getting my 80mm MAF in place. I have an adapter for
the
> MAF on the inlet side that should work fine mated up to the stock airbox
lid.
> I was planning on using a piece of SS exhaust pipe for the run from the
end of
> the MAF to the TB. Was gonna stay with the 3.5in diameter that the MAF
lets
> out with all the way up to the TB.
>
> I know that I can spend $42 for a 3.5in to 3in reducing coupler in
silicone #
> F2HZ-6C640-G from Ford. But being the cheap bastard that I am I'd love to
find
> another cheaper source. I've been looking around the home depot and I'm
not
> sold on anything there. Specifically because there is no give in any of
the
> plumbing connectors. I want something that will give a little as the
engine
> moves around the very little that it does (thanks to kirk's mounts) and
I'm
> not going the clothes dryer duct route.
>
> What I want doesn't even have to be silicone, plain old rubber couplers
would
> do fine too. I'm searching around the net, but haven't found anything good
> yet. If anyone knows of a place that I should look please let me know
>
> Bruce
> 94 Opal Frost MTX
> 94 Deep Emerald Green ATX - w/90k gonna be parted
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes