[Shotimes] MAF connector question

[Rick Glass]

Sounds like the MAF you have doesn't belong on your SHO, if it did the
connector would fit properly.  The SHO came with a 55mm MAF, where did the
80mm you are running come from?  I know the Thunderturd MAF has been used on
SHO's in the past, but causes problems because they weren't compatible with
the PCM or something like that.
This is all I have to say, I'm no mechanic or specialist, just going on
previous heresay.

One of the other guys will probably have the correct information you are
looking for.

Rick Glass

'99 Silver
"94 Yellow ATX


----- Original Message -----
From: "van Oss" <vanOss@centurytel.net>
To: <shotimes@autox.team.net>
Sent: Thursday, August 14, 2003 11:26 PM
Subject: [Shotimes] MAF connector question


> My 92 wears a Ford 80mm MAF (housing and sensor electronics).   I recently
> had an intermittent CE light with bucking at anywhere above minimal
> throttle.
>
> Turns out, the "car" side of the MAF connector was slipping off the MAF.
> The physical dimensions of connectors seem to be a problem, because the
> connector will not latch.
>
> Has anyone else had this problem?  Should I just remove the prongs from
the
> connector?
>
> Joseph van Oss
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes