[Shotimes] MAF connector question

[Midwest SHO Specialists]

Joseph,

I've never personally run across that problem.

You could just crimp one piece of the plastic to form a press fit over the
male portion of the plug.  That should be enough to hold it.

Do you have an A/F chart with that MAF installed?  I have yet to see a Ford
80mm MAF/ LPM combo that worked out of the box.  The best gains come when
you send Ted your chip and a chart.

Mike Kopstain
Midwest SHO Specialists
827 North Chestnut Avenue
Arlington Heights, IL 60004
www.MidwestSHO.com
Sales@midwestsho.com
----- Original Message -----
From: "van Oss" <vanOss@centurytel.net>
To: <shotimes@autox.team.net>
Sent: Thursday, August 14, 2003 11:26 PM
Subject: [Shotimes] MAF connector question


> My 92 wears a Ford 80mm MAF (housing and sensor electronics).   I recently
> had an intermittent CE light with bucking at anywhere above minimal
> throttle.
>
> Turns out, the "car" side of the MAF connector was slipping off the MAF.
> The physical dimensions of connectors seem to be a problem, because the
> connector will not latch.
>
> Has anyone else had this problem?  Should I just remove the prongs from
the
> connector?
>
> Joseph van Oss
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes