[Shotimes] Heater host Q

[Rick Glass]

I couldn't find them either, I simply used my grinder to VERY CAREFULLY cut
the pressed metal fitting and the rubber hose off of the end, without
damaging the lip on the metal pipe, then repalced that with new hose and a
clamp....no problems works great, cost about $3 for all of the clamps and
hose and about 30 minutes of my day.
Hope this helps.

Rick Glass

----- Original Message ----- 
From: "Edward Mazurek" <emazurek@cisco.com>
To: <shotimes@autox.team.net>
Sent: Saturday, August 23, 2003 10:35 AM
Subject: [Shotimes] Heater host Q


> Hi...
>
> 95 MTX
>
>
> I'm trying to replace all the hoses while I'm doing my
> maintenence. There are two short moulded hoses that go
> to/from the heater core by the firwall. I ordered what
> thought would be the two hoses. One is:
>
> V6 MTX Heater hose - tube w/ head tab to heater core KH-295 E9DZ-18472-D
>
> This one seems right.
>
> The other one is:
>
> V6 MTX Heater hose - tube w/ intake tab to heater core E9DZ-18472-E
>
> This one doesn't seem to math the other hose. The hose that is on the car
is
> an "S" shaped moulded hose. It has E9DH-180359-DA (I think) stamped
> on the side. The E9DZ-18472-E hose is completely different as it only has
> about a 45 degreee bend.
>
> I have two questions:
>
> How do I get this hose? No one seems to list it.
>
> What is the E9DZ-18472-E hose for?
>
> Thanks,
>
> Ed Mazurek
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes