[Shotimes] rear calipers sticking
Paul Nimz
niks@dialnetwork.com
Fri, 5 Dec 2003 09:51:07 -0600
I went through all this, this summer on my '93. If the hoses are restricted
you will get a very slow drip with the bleeder screw removed. With good
hoses you get a drip every 3-5 seconds.
Paul Nimz
'97 TR
'93 EG mtx
----- Original Message -----
From: <Mike.Wojton@us.o-i.com>
To: <shotimes@autox.team.net>
Sent: Friday, December 05, 2003 9:35 AM
Subject: Re: [Shotimes] rear calipers sticking
> No, but the rear calipers bleed fine. But I guess it still could
> be the hoses. There's a lot of pressure in them when bleeding,
> but not much going the other way. They could be swollen just
> enough. I planned on replacing the lines eventually. May have
> to do it sooner now.
>
>
> Mike Wojton
> Toledo, Ohio
>
> -'95 White MTX
> '96 Brake Upgrade
>
> Do not taunt Happy Fun Ball.
>
>
>
>
> "Paul Nimz" <niks@dialnetwork.com> wrote on 12/05/2003 10:06:40 AM:
>
> > Have you changed the hoses?
> >
> > Paul Nimz
> > '97 TR
> > '93 EG mtx
> >
> >
> > ----- Original Message -----
> > From: <Mike.Wojton@us.o-i.com>
> > To: <shotimes@autox.team.net>
> > Sent: Friday, December 05, 2003 8:15 AM
> > Subject: [Shotimes] rear calipers sticking
> >
> >
> > > I've been having a problem with my rear calipers. When I release the
> > > parking brake, they want to stick for a while. So much so that the
> car
> > > won't roll down my driveway on its own.
> > >
> > > Both calipers are new NAPA units. In fact, I replaced one of them
> > > again because the replacement leaked around the piston. The slide
> > > pins should still be greased up good. The cables were just replaced
> > > last month. The shop that did the cables played with the adjustment,
> > > and they're convinced that the calipers are sticking. They had the
> > > cables adjusted so far out that when the pedal was released, there
> > > was no tension on the caliper. I'm convinced.
> > >
> > > This only happens when it is pretty cold out. (of course, it's going
> to
> > > start happening alot more now) What are the odds that the calipers
> > > are bad again? Maybe a batch of calipers were remanned with too
> > > tight of tolerance in the pistons? Or, because it only does it when
> > > it's cold, if the caliper housing and the piston were different
> materials,
> > > they contract differently in the cold? I thought I read where they
> can
> > > have steel or phenolic pistons. I won't know what I have until I take
> > > them off again.
> > >
> > > So, anybody ever have this kind of problem before? Any comments?
> > > Constructive, that is. ; )
> > >
> > >
> > > Mike Wojton
> > > Toledo, Ohio
> > >
> > > -'95 White MTX
> > > '96 Brake Upgrade
> > >
> > > Do not taunt Happy Fun Ball.
> > > _______________________________________________
> > > Shotimes mailing list
> > > Shotimes@autox.team.net
> > > http://www.team.net/mailman/listinfo/shotimes
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes