[Shotimes] Alignment Products, Problems to begin with

[Johnsho92]

Hello,

has anyone has any expeirnce and would like to share
about this particualar Front-Camber kit?

 1) Install the Specialty Products front camber kit
#89625 to gain more 

> positive camber adjustment.

This was quoked from the FAQs under one the articles..
 I went to the site, and they dn't have the info on
file, but they do have three Kits for rear camber.. 
One wasm particularly odd, they basically have a
template to drill new holes for the strut-Mount-Studs,
marked by #s representing degrees of change..   How
interesting.  Would the front setup seem similar?  is
it safe to drill through the Strut-Towers?  

Thanks..

I'm looking towards this becuase my my Front camber
with new OEM springs that are hieghten about 2 1/2
inches, I think the codes are JJWW, which JJs are
fronts.  Still I have too much negative Camber..  :(  
Cambers-
Drivers:-0.4  Passngr: -1.7    

I don't think it's a big deal, but then again I don't
know why they're so non-symetrical.  I've changed the
struts and all, inspected them agian to make sure it;s
not bent to my knowledge..  Weird!  

thanks a lot..


-john


__________________________________
Do you Yahoo!?
Free Pop-Up Blocker - Get it now
http://companion.yahoo.com/