[Shotimes] Newcomer with a new problem

[Paul L Fisher]

Uh.... You started out by saying oil LEVEL sensor and the went on to say you
changed it by reaching way up on the back of the motor. That is where the
PRESSURE sensor is. Which one are you talking about?

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 171K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back, Holley
190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar, Performance-Plus
Stainless Steel Y-pipe, Delrin sub-frame bushings, Amsoil Series 2000 0W-30
oil, Amsoil Synthetic ATF.
'00 Ford Explorer XLT 5.0L V8 AWD Oxford White Clearcoat 41K Build date
11/19/1999
- Amsoil Series 2000 0W-30 oil, K&N Fuel Injection Performance Kit

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm

Get $5 free from Paypal! https://www.paypal.com/refer/pal=P3XEFFBFUFKN6

----- Original Message -----
From: "Michael Humbert" <humbem@rpi.edu>
To: <shotimes@autox.team.net>
Sent: Friday, February 07, 2003 9:00 PM
Subject: RE: [Shotimes] Newcomer with a new problem


> To quell your disbelief, just last spring I had my oil level sensor
> start leaking, and man did it pour out.  It started off as a slight leak
> coming out the back of the motor, and within one week (and one 200 mile
> trip going about 90 mph on average) the slow leak became a steady
> dripping.  It was so bad that my car leaked a quart of oil about every
> 10 miles.  It also made for some fun when the cats got heated up a bit.
> I definitely got some crazy looks that week with the smoke billowing out
> from under my car.  It was upon inspecting the engine that I immediately
> found the leak to be coming from the sensor.  Unfortunately, it was
> nearly impossible for me to get to the sensor with my car just jacked
> up.  For this reason, I had to bring it to the shop and put it on a lift
> to be able to reach and replace it.  If you have long arms you can
> definitely do it from the flat of your back quite easily.  The best part
> about it, $6 for the repair.  One of the few endeavors with the SHO that
> didn't hurt my skinny wallet.
>
> -Mike Humbert
> 90 titanium w/ 159k
>
> ----Original Message----
> From: "Ron Porter" <ronporter@prodigy.net>
> To: <shotimes@autox.team.net>
> Subject: RE: [Shotimes] Newcomer with a new problem
> Date: Fri, 7 Feb 2003 15:58:32 -0500
>
> No offense to you, Paul, but as ANYONE had the oil pressure sensor start
> leaking? The culprit for years was the oil level sensor gasket (and
> sometimes the sensor itself) in the oil pan. Now that the cars are
> older, the oil pan gaskets are becoming a common leak (BTDT). I have
> talked to a bunch of folks with either of the above two starting to
> leak, but I've never heard of the oil pressure sensor (up high on the
> block on the drivers side) leaking from anyone I've talked to.
>
> Ron Porter
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes