[Shotimes] loose bulb
Donald Mallinson
dmall@mwonline.net
Fri, 21 Feb 2003 09:00:44 -0600
Joseph,
The silicone treatment might work, but it also might be very
hard to remove if the bulb burns out. Why not try a gob of
the dielectric grease (same stuff used on brake slider
pins). Factories use this to seal and stabilize lots of
factory bulbs. might be just enough to keep it from moving.
Don Mallinson
van Oss wrote:
> In my 91 SHOable, there's a problem with one of the lamp fixtures. It accepts a 194 bulb. 1 in 3 times that I shut the hood, the
> vibration is enough to shake the bulb loose. Any ideas how to keep the bulb lodged in there a little stronger? Thanks.
>
> The offending fixture is in the Mercury Sable front-center "laser" bar that I retrofitted onto my 91 SHO. The lamp I actually use
> might not technically be considered 194 although it's exactly the same shape. I go to Home Depot and buy the 18-watt bulbs intended
> for landscape lights.
>
> Is there some goop that would stand high bulb temps? TIA for any help.
>
> Joseph van Oss