[Shotimes] Cam position sensor replacement process
Erik Balser
masho95@charter.net
Fri, 28 Feb 2003 14:50:15 -0500
As far as I know you just need to replace the plastic piece. I replaced just
the plastic part on my '95 when it was acting up and it totally cured the
problem. I don't see why you'd need to replace the aluminum base as the
sensor is in the plastic part. Good luck!
'95 MTX
Erik B.
http://webpages.charter.net/masho95
----- Original Message -----
From: "john marmaduke" <jmarmadu@yahoo.com>
To: "SHOTimes" <shotimes@autox.team.net>
Sent: Friday, February 28, 2003 1:42 PM
Subject: [Shotimes] Cam position sensor replacement process
> I need to replace my cam position sensor on my 95 ATX. The new sensor
comes
> complete with the plastic sensor and aluminum base. My question is, can I
> just replace the plastic sensor part on the car (it looks a lot easier),
or
> do I need to replace the sensor as a whole?
>
> Thanks,
> John
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes