[Shotimes] GenIV Seats In A GenII

[Bob and Anonda]

Should be doable, but not without some fabrication and cutting.  The Gen 3/4
rear seat back bolts in with 4 bolts to the trunk panel, as opposed to the 2
bolts and clips used in the Gen 1/2.  Not sure how the top of the seat would
look against the rear shelf though, and you would need to cut away part of
the trunk wall to take advantage of the fold down option.  Bracing may be
required after this, as you'd be cutting out a structural member of the
Flex-o-matic Gen 1/2 body.

Bob
----- Original Message ----- 
From: "Dave Kegel" <d.kegel@comcast.net>
To: <shotimes@autox.team.net>
Sent: Tuesday, July 08, 2003 11:24 AM
Subject: Re: [Shotimes] GenIV Seats In A GenII


> Sorry, I was only referring to the lower seat cushion.  I have no idea how
> you would get a Gen3 rear seat back to work, as they are setup to fold
down.
>
> Dave Kegel
> ----- Original Message -----
> From: "Peter Maggiacomo" <gtsrider@yahoo.com>
> To: <shotimes@autox.team.net>
> Sent: July 08, 2003 9:19 AM
> Subject: [Shotimes] GenIV Seats In A GenII
>
>
> > Dave, so I have a 95MTX, and if I understand you
> > correctly, I could go to a recycle yard and put in
> > 03 Taurus seats in my 95MTX, front AND rear? Thanks.
> > -Pete
> >
> > __________________________________
> > Do you Yahoo!?
> > SBC Yahoo! DSL - Now only $29.95 per month!
> > http://sbc.yahoo.com
> > _______________________________________________
> > Shotimes mailing list
> > Shotimes@autox.team.net
> > http://www.team.net/mailman/listinfo/shotimes
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes