[Shotimes] A/C problems.

[MICHAEL SHELBY]

As mentioned earlier, the hub-and-disc are one piece.
There is a rubber section molded to hold the hub and
the disc together. 

As it turned out, the disc had worn down to the rivits
on my A/C clutch. I ended up replacing all three parts
with the autozone kit. The snap ring holding the coil
on is a major pain in the @$$! If anyone has advice on
how to get that ring on and off, I'm sure future
DIY'ers would appreciate it. 

Thanks for the advice!

'94 SHO with working A/C 


On Thu, 10 Jul 2003 23:03:07 -0500, "van Oss" wrote:

> 
> What do you people mean by the "disc"?  In the parts
> kit I received, and in
> all the drawings I found, there are only three parts
> that can be replaced:
> 
> -- hub
> -- pulley with bearing
> -- field coil
> 
> I can find no disc.  What's up with that?
> 
> Joseph
> 
> 
> ----- Original Message -----
> From: "Dave Kegel" <d.kegel@comcast.net>
> To: <shotimes@autox.team.net>
> Sent: Thursday, July 10, 2003 9:05 PM
> Subject: RE: [Shotimes] A/C problems.
> 
> 
> I would try just the disk and hub.  Most of the time
> that's all you
> need.
> 
> Dave
> 
> -----Original Message-----
> From: shotimes-admin@autox.team.net
> [mailto:shotimes-admin@autox.team.net] On Behalf Of
> MICHAEL SHELBY
> Sent: Thursday, July 10, 2003 8:59 PM
> To: shotimes@autox.team.net
> Subject: Re: [Shotimes] A/C problems.
> 
> 
> Ok, you were right. The outer part of the clutch hub
> was spinning, but not the center section. With the
> engine off I can spin the compressor by hand so I
don't
> think it is siezed.
> 
> I can get just the disc and hub for $37 from the
> dealer, or the entire clutch (coil, pulley, disc and
> hub) for $90 from autozone.  Both places have the
parts
> in stock. Is it ok to replace just the center section
> or should I put in all of the parts?
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes

________________________________________________
PeoplePC:  It's for people. And it's just smart. 
http://www.peoplepc.com