[Shotimes] Is SHOTIMES FAQ being maintained for content? (was Clearing continuous codes from memory.)

[Carl Prochilo]

I am getting a sense that SHOTIMES is not being updated.  I had sent the
webmaster some information a few months ago to be added to the mechanics
Hall of Fame on behalf of Don D that never got posted.

If there is someone still maintaining content, there is an error in the Care
and Feeding Section --> EEC Self-Test Procedure --> Clearing Continuous
Codes .  The text describes the following statement.
"To clear continuous codes, disconnect and then reconnect your jumper after
all the tests have been run and codes received."

The statement should correctly read as follows.
"To clear continuous codes, disconnect and then reconnect your jumper while
the continuous codes are being displayed."

Cheers,
Carl Prochilo
92 Ultra Red Crimson
----- Original Message ----- 
From: "Carl Prochilo" <gr8sho@prochilo.myserver.org>
To: <shotimes@autox.team.net>
Sent: Friday, June 13, 2003 5:35 PM
Subject: Clearing continuous codes from memory.


> I tried to follow the procedure on the Shotimes FAQ but I wasn't able to
> clear the codes.  Will I get the same effect if I disconnect the ground
from
> the processor?  Any other tricks to getting these codes cleared?  I want
to
> make sure I can capture a fresh set of codes in case the CEL comes on
again.
>
> Cheers,
> Carl P.