[Shotimes] Speedo Cable Retaining Clip

[Steve Weinrich]

You need to specify WHICH end of the cable you are working with.

If it's at the speedo head, you have to squeeze the clip properly to release
it.

At the connection in the engine compartment, pull the metal wire clip and
then separate the halves.

At the tranny, you're on your own, haven't done that one.

At the speedo head, it's easier if you disconnect the halves, then remove
the cluster from the dash , pulling the cable from the firewall.  Once you
can actually see the speedo head connection, it's easy to see how to
disconnect it.  I have large hands, so I can't get to the connector while it
is still installed in the dash.

My experience is on an 89.  Since you didn't SAY what you're working on.....

Steve

----- Original Message -----
From: "jared gardner" <jmcbgardner@hotmail.com>
To: <shotimes@autox.team.net>
Sent: Wednesday, March 12, 2003 8:48 AM
Subject: [Shotimes] Speedo Cable Retaining Clip


> So I was trying to remove this clip last night to lube my speedo cable and
I
> could not get the stupid clip to release.  Is there some secret to their
> removal?  I was pulling quite hard.
>
> Jared Gardner
>
>
>
>
>
> _________________________________________________________________
> Add photos to your e-mail with MSN 8. Get 2 months FREE*.
> http://join.msn.com/?page=features/featuredemail
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes