[Shotimes] Gen II fenderwell cladding piece installation

[Herman Anker]

Sorry for sounding blunt, but if I remember well, body is described pretyy vell in HElms manual. It hs been said a million times before, Helms manual will save SHO owners money down the road. Buy it on day 1 of ownership.

fwhittle@mindspring.com wrote:

>      I'm trying to install the aforementioned piece, the one that goes behind the rear door.  I ended up breaking off the white clip at the top (the plastic "welds" broke, so I'm thinking that epoxy would work fine to fix it).  Is there a trick to installing this piece that I'm overlooking?  The clip broke off when I tried to bend the piece enough to slide it over the clips at the bottom.  Should I have a helper hold the top against the body while I bend it to install the bottom?  Any better ideas?
>
> Thanks.
>
> Frank Whittle
> '95 ATX
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes

--
_______________________________________________________________________________

'95 ATX  ~139 000 km
Mods&Service page: http://hanker.tripod.com/sho.htm
Ontario SHO enthusiast club: http://www.shopower.com/
High tech Automotive lighting faq: http://faq.auto.light.tripod.com
_______________________________________________________________________________