[Shotimes] Fram oil filter
Donald Mallinson
dmall@mwonline.net
Thu, 08 May 2003 09:15:05 -0500
Mike,
There is a very good article with cut-up filteres of most
major brands by Tim Wright on the SHOclub.com web site.
Go to:
http://shoclub.com/lubrication-oil/lubrication-oilpart1.htm
Don Mallinson
sho2go wrote:
> I have strong doubts, Mark. If you consider the flow by the time the filter
> goes into bypass, its up greater than 5 gpm as high as the pump will flow,
> maybe 11-12 gpm. Thats a tremendous amount of turbulence washing right by
> the folds, and I am quite sure a good portion of the debris will go along
> for the ride.
> Mike
>
> ----- Original Message -----
> From: "Mark Mallory" <mmallory78@earthlink.net>
> To: "sho2go" <srfdude@cox.net>; <shotimes@autox.team.net>
> Sent: Wednesday, May 07, 2003 5:36 PM
> Subject: Re: [Shotimes] Fram oil filter
>
>
>
>>I think it's a pretty safe bet that any contimnats will stay in the folds
>
> of
>
>>the filter. Look at an air filter... even larger debris stays within the
>>filter folds until you physically separate the folds. The more common
>>smaller particles will embed themselves in the filter and there is no
>>concern about them "falling" into the bypass stream.
>>
>>Mark Mallory
>>Toledo, Ohio
>>'95 SHO MTX
>>
>>----- Original Message -----
>>From: "sho2go" <srfdude@cox.net>
>>To: <shotimes@autox.team.net>
>>Sent: Wednesday, May 07, 2003 7:54 PM
>>Subject: [Shotimes] Fram oil filter
>>
>>
>>
>>>I just changed my oil/filter after an AutoRx treatment, the filter was
>>
> the
>
>>>Fram PH3600. Cut it open to see what was in there (this was on my '90
>>
>>w/150K
>>
>>>miles) and found the bypass valve to be on the bottom. Pretty black,
>>
> but
>
>>no
>>
>>>gritty stuff. Has anyone cut any of the normal suspects for an SHO
>>
> filter
>
>>>apart to find the bypass on the top (where it should be)? The oil forum
>>
>>tests
>>
>>>are showing that just about all filters will go into bypass at either
>>
> cold
>
>>>temps, or high revs; I hate to think all the stuff thats filtered out
>>
> just
>
>>>washes right through the bypass, when its on the bottom (opposite the
>>
>>screw-on
>>
>>>end).
>>>Mike
>>>_______________________________________________
>>>Shotimes mailing list
>>>Shotimes@autox.team.net
>>>http://www.team.net/mailman/listinfo/shotimes
>>
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes