[Shotimes] Y-Pipe to Manifold studs

[Ron Porter]

OK, so I don't need to spend $20 on a carbide drill and manifold studs &
nuts, I can sell my $Ron Porter 275K 2,500 sq/ft home plus an 1,100 sq/ft
walkout basement on a 1/2 acre lot, and buy the same home for $1.2-1.5
million, plus put up with all of the f**ked up politics in CA?

I think I'm willing to lay on my back with a drill and go through that BS
again, thank you very much!!

FWIW, I can get CA weather in other states without the CA BS. Yes, I know
about it, my brother lives in Irvine.



-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of sho2go
Sent: Thursday, May 08, 2003 5:20 PM
To: 'SHOTimes'
Subject: Re: [Shotimes] Y-Pipe to Manifold studs


Or, of course, you could move to CA; George and I don't even use PB whatever
;-)
Mike

----- Original Message ----- 
From: "Ron Porter" <ronporter@prodigy.net>
To: <stevetatro@att.net>; "'SHOTimes'" <shotimes@autox.team.net>
Sent: Thursday, May 08, 2003 1:07 PM
Subject: RE: [Shotimes] Y-Pipe to Manifold studs


> If the studs will break trying to get the old nuts off, they will also
break
> trying to put new nuts on (after cracking off the old ones).
>
> Give the old ones a try after PB Blaster. If they don't budge, then use
> heat. Of course, even with heat, mine broke anyway!!
>
> If they break, don't even waster your time with a stud extractor....that
> will break also, and cause more grief. Go right to Home Depot and get a
> carbide drill. Forget the cobalt drills, they are worthless on
heat-hardened
> exhaust parts.
>
> Ron Porter
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes