[Shotimes] wheel bearing

Dave Kegel Dave Kegel" <d.kegel@comcast.net
Fri, 10 Oct 2003 09:31:53 -0500


Loosen the axle nut.
Jack up the car and remove the wheel.
Disconnect the brake caliper.
Remove the rotor
Disconnect the LCA from the knuckle.
Disconnect the tie rod end.
Remove the pinch bolt.
Slide the knuckle/strut assembly out from the axle.
Slide the knuckle down off the strut.
Take it to a local Napa, CarQuest, what have you and have them press in a
new bearing.

Dave Kegel

----- Original Message -----
From: <Mike.Wojton@us.o-i.com>
To: <shotimes@autox.team.net>
Sent: October 10, 2003 9:22 AM
Subject: RE: [Shotimes] wheel bearing


> So pulling the hub means removing the strut from the pinch right?
> I'm trying to picture it in my mind.  There's a lot of other useless
> stuff in the way.  In my mind that is.  Pop it off the ball joint,
> pull strut out.  That's about it right?  Except for replacing bearing,
> of course.
>
>
> Mike Wojton
> Toledo, Ohio
>
> -'95 Green MTX  3/01-1/03
>    ShoShop y-pipe
>
> -'95 White MTX
>    '96 Brake Upgrade
>
> Putting the F U back in fun.
>
>
>
>
> shotimes-admin@autox.team.net wrote on 10/10/2003 09:12:25 AM:
>
> > Pull the hub
> > Go to a press
> > Flip unit upside down
> > Press out hub
> > Remove clip ring  (eye protection required)
> > Flip over
> > Press bearing out
> >
> > To install do the reverse
> >
> > Kirk J Doucette
> > NESHOC President
> > Stormtrooper-97 White
> >
> > -----Original Message-----
> > From: shotimes-admin@autox.team.net
> [mailto:shotimes-admin@autox.team.net]On
> > Behalf Of Mike.Wojton@us.o-i.com
> > Sent: Friday, October 10, 2003 8:41 AM
> > To: shotimes@autox.team.net
> > Subject: [Shotimes] wheel bearing
> >
> > Because I fear Ron Childs, and what he stands for, I have a SHO related
> > question.
> >
> > What is involved in changing a front wheel bearing?  Does just the hub
> > come
> > off by itself?  Or do you have to tear the whole thing apart?  I knew I
> > should
> > have replaced them when I did the front end this summer.
> >
> >
> > Mike Wojton
> > Toledo, Ohio
> >
> > -'95 Green MTX  3/01-1/03
> >    ShoShop y-pipe
> >
> > -'95 White MTX
> >    '96 Brake Upgrade
> >
> > Putting the F U back in fun.
> > _______________________________________________
> > Shotimes mailing list
> > Shotimes@autox.team.net
> > http://www.team.net/mailman/listinfo/shotimes
> > _______________________________________________
> > Shotimes mailing list
> > Shotimes@autox.team.net
> > http://www.team.net/mailman/listinfo/shotimes
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes