[Shotimes] GEN 1 - Bell Housing nose cone wear and repair

[Fred George]

Hi folks!

During a clutch replacement project, we found that the nose cone, that 
cylindrical section of the bell housing upon which the clutch throw-out 
bearing rides, has been worn down in the middle so that it has a coarse, 
"coke bottle" taper in the mid secion. Any suggestions on how to fill up 
the wear section with TIG or MIG weld and then mill it down to original 
diameter?

Anyone know the stock diameter of the nose cone cylinder?  Car is at A V 
Auto in Linda Vista, tying up Andy's rack while we're awaiting help with 
this one.

Thanks.

Fred
Insane Diego
619.275.0222