[Shotimes] GEN 1 - Bell Housing nose cone wear and repair

[Mark Nunnally]

wow never seen that before.

the rev b bearing will ride on the quill sleeve, will the sleeve fit on the
quill ok?  if so just put some sleeve retainer on there and stick the sleeve
on it

mark

----- Original Message -----
From: "Fred George" <fgeorge@pacbell.net>
To: <shotimes@autox.team.net>
Sent: Tuesday, September 16, 2003 4:57 PM
Subject: [Shotimes] GEN 1 - Bell Housing nose cone wear and repair


> Hi folks!
>
> During a clutch replacement project, we found that the nose cone, that
> cylindrical section of the bell housing upon which the clutch throw-out
> bearing rides, has been worn down in the middle so that it has a coarse,
> "coke bottle" taper in the mid secion. Any suggestions on how to fill up
> the wear section with TIG or MIG weld and then mill it down to original
> diameter?
>
> Anyone know the stock diameter of the nose cone cylinder?  Car is at A V
> Auto in Linda Vista, tying up Andy's rack while we're awaiting help with
> this one.
>
> Thanks.
>
> Fred
> Insane Diego
> 619.275.0222
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes