[Shotimes] Still stalling - Cleaned IAB

[Kevin & Cheryl Airth]

You probably will need to replace it. I have not had much luck cleaning them
for the same reason. It's all crimped together so you can't get to it! Plus
Ford did release an improved version.
.
.


> I followed the directions on the FAQ for cleaning the IAB.  Got it off
with no
> problems, but I did note that the ISC would not come off the IAB.  It is
> 'crimped' onto the IAB.  There was some fouling and I emptied a can of
carb
> and choke cleaner into the IAB, got lots of stuff out.  I couldn't move
the
> piston though.
>
> The car started and it was idling for about 5 minutes (yah! :)    There a
new
> 'rushing' noise and then she stalled.  Couldn't get her to idle after
that.
> Took a hard drive up and down the local highway.  Still wouldn't idle.
> Disconnected the ISC, still wouldn't idle.
>
> Any thoughts out there?  I'm concerned 'cause my IAB/ISC combo won't come
> apart like described in the FAQ and pictured in my Chiltons.
>
> Bruce Malachuk I'll trade you for a house call.
>
> Mike Piplani
> '94 ATX
> Delmar NY
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes