[Shotimes] removing crankshaft front oil seal

[Kenneth Epperly]

Punch a small hole in the metal part of the seal insert a sheet metal screw
and pull out. Are you in NJ?

        Ken

----- Original Message ----- 
From: <cmichaelo@optonline.net>
To: "shotimes" <shotimes@autox.team.net>
Sent: Sunday, August 08, 2004 4:46 PM
Subject: [Shotimes] removing crankshaft front oil seal


> Hi,
>
> I'm my quest to stop oil leaks, I'm now ready to replace the crankshaft
front oil seal. Manual says to use a "Locknut pin remover". I don't have
such.
>
> How else can this seal be removed? I tried using my Hook & Pick Set, but
that just taers the rubber off little by little. Do I need this "locknut pin
remover"?
>
> Then when installing it manual mentions using some special tool (looks
like a huge axle nut remover). Again, I don't have this thing. Is it really
needed?
>
> Michael
> 94MTX,green,BOS+
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes