[Shotimes] Cam Sensor Replacement

[Beisler Jonathon]

Dave,
Some people have said this is a difficult job, but I have found it to be
rather easy.  There is no special tool that is required, just a screwdriver
or nut driver, depending on what is holding it all together.  Mine had
Phillips head screws that came out very simply.  There is the sensor
connector that has to come off and then the two screws and it pops right
out.  It is a little hard to get to behind the power steering pump pulley,
but I did mine in maybe ten minutes.  You don't need any particular part.  I
bought the aftermarket Wells part at Autozone for 20 or 30 bucks two years
ago and have not had a problem with it.  I said it was a fool proof install
once but got some flack for that as those damned fools are so ingenious.
JB