[Shotimes] Some Aftermarket Parts No Good?....was: Speedometer Cable Lengths

[Kenneth Epperly]

92 is the same cable as I put one in from a 89.

        Ken
----- Original Message ----- 
From: "George Fourchy" <krazgeo@comcast.net>
To: <shotimes@autox.team.net>
Sent: Wednesday, December 15, 2004 2:05 AM
Subject: Re: [Shotimes] Some Aftermarket Parts No Good?....was: Speedometer
Cable Lengths


> On Wed, 15 Dec 2004 00:28:44 -0600, Paul Nimz wrote:
>
> >The speedo itself would accept the other cable but apparently the
> >two halves are a matched set.
>
> I only know about Gen 1 peculiarities....Gen 2 would want to be the same
if they are
> mechanical, but I know not for sure.  I can check next time I'm at
PnP...but it
> would be SLOs I'd be looking at.
>
> The only fact I know for sure is that single cables from the 3.8 ATX SLO
will
> interchange with the upper cable of a Gen 1 MTX.  That is a very good
thing.  The
> slide and ridge lower end of both the upper and lower cables are the same,
and will
> both snap into a speed sensor, or into another lower cable's upper end.
>
> I guess it's time for pictures on the tune up page.
>
> George
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes