[Shotimes] PIAA 1500XT driving lights--question

[Herman Anker]

I can confirm the below text as well. The tough part is make holes though the 5mm steel bracket! On a sidenote, I havn't turned them on after I got these guys: http://hanker.tripod.com/headlight-level3-project.htm  (sorry about the popups...)

Rbade12@aol.com wrote:

>
> They require nothing but cutting and splicing to wire, no new wiring, relays,
> etc.. To mount, I believe I had to drill a couple holes in the back of the
> space they go in, it was pretty intutitive. I had, previously, done the foglight
> upgrade that spearates foglight control from high beam control, so instead of
> having to reach down and push the button to turn off and on, I added the
> button switch with the long wire PIAA provides, simply spliced it into the
> foglight switch. I removed my ashtray and bunch it up and store it there. When I use
> it, dependent on the intensity of driving, I use the velcro strap and mount it
> to the shifter knob or I strap it to a finger or the steering wheel [careful
> with this, don't limit steering travel].
>
> Good luck!
>
> Bob 93 MTX
>        91 Audi 200q20v
>        96 VW Passat GLX VR6
>        01 Taurus w/ Duratech
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes

--
_______________________________________________________________________________

'95 ATX  ~139 000 km
Mods&Service page: http://hanker.tripod.com/sho.htm
Ontario SHO enthusiast club: http://www.shopower.com/
High tech Automotive lighting faq: http://faq.auto.light.tripod.com
_______________________________________________________________________________