[Shotimes] Replacing motor mount
Justin Jones
dr_jones35@hotmail.com
Fri, 02 Jul 2004 04:06:37 +0000
Seeing as i just replaced mine here we go...
1remove passenger side wheel
2 remove lower ball joints from steering knuckles.
3 support engine from below.
4 loosen rear subframe bolts and loosen front subframe bolts.
5 remove motor mount retaining nut from subframe.
6 slowly lower front of subframe using floor jack
7 once front of subframe is dropped remove lower radiator hose (may also
wanna remove starter for more room
8 remove 2 bolts holding front motor mount on using open end wrenches (and a
socket if you can make it fit)
9 replace mount
10 put eveything back together
if you have any questions just ask. i think i covered just about
everything...
Doc
_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar get it now!
http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/