[Shotimes] HELP REQUEST
alfitz@alfitz.com
alfitz@alfitz.com
Fri, 11 Jun 2004 11:52:50 -0500
I don't need the help, I was just forwarding a request I received on my web
site.
Al Fitz
alfitz@alfitz.com
GET YOUR YAMAHA-SHO EMBLEMS AT:
http://www.alfitz.com/sho/yamaha-emblems.htm
****************************************************************************
PLEASE INCLUDE A COPY OF THIS EMAIL IN YOUR REPLY
**************************************************************************
----- Original Message -----
From: "ROBERT SCHIRMER" <1surferbum@msn.com>
To: <alfitz@alfitz.com>; "_ShoTimes" <Shotimes@autox.team.net>
Sent: Friday, June 11, 2004 9:10 AM
Subject: Re: [Shotimes] HELP REQUEST
> AL (for your help request)
>
> This is based on my removal for my '93, 3.2 ATX starter (on the way to the
> removal of my oil pan). As you know, the starter is located up
underneath,
> near the drivers side of the radiator
>
> 1.. Starter removal
> 1.. Physical removal of the starter will start here, but the starter
> cannot be physically removed until the #1 electrical connector covered in
Step
> 2 below is done. The starter has two bolts that hold it in place. The
bottom
> bolt is a 13 mm. The top bolt is a 15 mm, and a real Pain to get on and
off.
> You must use a short socket on a 5 =" extension & an air ratchet; or you
can
> use a 2' extension and get to it thru the passenger side wheel well.
Putting
> the top bolt back into place during installation is a real pain.
> 2.. Oil Cooler removal
> 1.. remove the 2 small 8 mm bolts that hold the oil cooler in place
(to
> the radiator??). This will give you room to get to the starter electrical
> 3.. Starter electrical disconnection (there are 3 electrical
connections to
> the starter)
> 1.. . #1-Located on the drivers side of the starter, there is a stud
that
> physically holds the starter in place. It also has a large black wire that
is
> connected here. When you remove the nut, the stud comes with it. The long
side
> of the stud goes into the starter during installation.
> 2.. #2- located on top of the starter on the passenger side, there is
a
> push on connector that has a small electrical wire.
> 3.. #3- located on the passenger side of the starter, at the front,
there
> are 2 black /orange wires that connect onto this bolt. These are covered
by a
> red cover, which has to be pulled back to gain access to the nut.
> ----- Original Message -----
> From: alfitz@alfitz.com<mailto:alfitz@alfitz.com>
> To: _ShoTimes<mailto:Shotimes@autox.team.net>
> Sent: Friday, June 11, 2004 8:35 AM
> Subject: [Shotimes] HELP REQUEST
>
>
> Results from Form 1 of Page sho/parts-form.htm
>
>
> ------------------------------------------------------------------------
---
> --
> ---
>
> Year: 1993
> tranny: ATX (Automatic)
> xcolor: Green
> Icolor: Black
> Email: imyy4u@msn.com<mailto:imyy4u@msn.com>
>
>
> Request
> I am looking for information on how to change a starter I have a 3.2l
> engine.
> The car strts sometimes the battery seems good, all lights work. can you
> send
> me specs of where the starter is located and how to replace it.
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net<mailto:Shotimes@autox.team.net>
>
http://www.team.net/mailman/listinfo/shotimes<http://www.team.net/mailman/l
> istinfo/shotimes>
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes