[Shotimes] pulling computer

[Bruce Malachuk]

Spray the foam gasket on the top of the computer with a little silicone
lubricant, wait a minute or two and the comp will slide right out easily. 


Bruce J Malachuk

*	94 Opal Frost MTX 
*	93 Emerald Green MTX 
*	93 Black ATX - parts 
*	95 Silver Frost ATX SE - SLO 


-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of ROBERT SCHIRMER
Sent: Saturday, June 26, 2004 12:18 PM
To: shotimes@autox.team.net; Jeremy
Subject: [Shotimes] pulling computer

Guys

I am trying to pull my H3Z computer out of my 93, and replace it with a
D4U1 computer. My problem is that I can't get that old one out. Looking at
the depth of the pins on the D4U1, I believe I have pulled it about 3/4 way
out, but no amount of force I pull on it with will help the rest of the way.
I have enlisted the help of vise grips and all. Is this just a matter of
wiggling it and pulling? I noticed the back side of the D4U1 computer has a
built in nut.
When I get this computer out, is the cable bundle held in place by a screw??
  Thanks in advance
  Bob
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes