[Shotimes] pulling computer
ROBERT SCHIRMER
1surferbum@msn.com
Sat, 26 Jun 2004 14:33:59 -0400
Gentlemen
Thanks for the help- it was that damn bolt in the engine compartment that
hooks into the back of the computer that was holding it in Once I removed that
bolt, out she slid.
Bob
----- Original Message -----
From: Bruce Malachuk<mailto:bmalach1@nycap.rr.com>
To: 'ROBERT SCHIRMER'<mailto:1surferbum@msn.com> ;
shotimes@autox.team.net<mailto:shotimes@autox.team.net> ;
'Jeremy'<mailto:jeremy@carrieandjeremy.com>
Sent: Saturday, June 26, 2004 1:40 PM
Subject: RE: [Shotimes] pulling computer
Spray the foam gasket on the top of the computer with a little silicone
lubricant, wait a minute or two and the comp will slide right out easily.
Bruce J Malachuk
* 94 Opal Frost MTX
* 93 Emerald Green MTX
* 93 Black ATX - parts
* 95 Silver Frost ATX SE - SLO
-----Original Message-----
From: shotimes-admin@autox.team.net<mailto:shotimes-admin@autox.team.net>
[mailto:shotimes-admin@autox.team.net]
On Behalf Of ROBERT SCHIRMER
Sent: Saturday, June 26, 2004 12:18 PM
To: shotimes@autox.team.net<mailto:shotimes@autox.team.net>; Jeremy
Subject: [Shotimes] pulling computer
Guys
I am trying to pull my H3Z computer out of my 93, and replace it with a
D4U1 computer. My problem is that I can't get that old one out. Looking at
the depth of the pins on the D4U1, I believe I have pulled it about 3/4 way
out, but no amount of force I pull on it with will help the rest of the
way.
I have enlisted the help of vise grips and all. Is this just a matter of
wiggling it and pulling? I noticed the back side of the D4U1 computer has a
built in nut.
When I get this computer out, is the cable bundle held in place by a
screw??
Thanks in advance
Bob
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net<mailto:Shotimes@autox.team.net>
http://www.team.net/mailman/listinfo/shotimes<http://www.team.net/mailman/l
istinfo/shotimes>