[Shotimes] Intake Sensor Modification Resistor.

[ROBERT SCHIRMER]

Guys

this item ( Intake Sensor Modification Resistor)  is on ebay for sale. Anybody
have any experience with this kind of thing???

Curious in Va
Bob

***********************
 Each one of the modifications use a specific and unique resistance value
listed below based on the electrical system of the specific vehicle.  A list
of these values matched to each vehicle can be provided upon request.  These
83 various values range from 100 to 9,500 ohms.  We have no more than 10
listings which use identical resistance values.



This modification for the Ford Taurus SHO has a resistance value of  4,400
ohms to override the sensor and signal the computer that the engine is
receiving air at the optimum temperature of 36 degrees.



Warning to customers:

Please do not attempt to purchase the part from a hardware or electronics
store and install it without our directions.  Incorrect installation,
resistance value or heat capacity could cause damage to your electrical
system.



-----------------------------------------------------------------------------
---

Ford Taurus SHO



This auction is for an Intake Sensor Modification Resistor. This modification
resistor will give you very similar results that an ECU (Electronic Control
Unit) upgrade chip will do. This modification connects to you intake sensor.
It works by causing fooling your ECU into thinking that the air coming into
the intake is colder therefore causing it to advance the timing and letting
out the fuel supply creating more horsepower. This is a resistor that will
modify your Air/Fuel ratio and slightly change your engine timing to run
stronger and with increased power.




This Intake Sensor Modification Resistor will fit just about all models and
make of cars and trucks from 1987 and newer that are fuel injected (non
Turbo). Its extremely easy to install no tools are required and this
modification resistor will not damage your vehicle in anyway!!! This only
takes about 10 minutes to install.




All parts are INCLUDED with easy to follow step by step instructions. This
do-it-yourself kit takes little to no knowledge of cars and is extremely easy
to install.




This resistor is a fraction of the cost of those expensive ECU upgrades
($400-$800)

Usually these upgrades void your factory warranty and also require

Soldering to you computer, and can cost thousands to replace if done wrong.

This does the same exact thing adds up to 20 HP!