[Shotimes] Gen2 door on a Gen1

[Rick Glass]

Since no one else offered any onfo about the way the handle attaches, I will
try.......The back of the G2 handle has a small offset tab that hooks on the
sheetmetal in the door and then the screw holds it in place......this is the
best way I can describe it from memory.....
I too, was confused the first time I took my '94 door panel off...but then
again I stay confused...
Hope this helps......

Rick Glass
   Nashville, TN
   SESHOC
'99 Silver 48k (these freakin' things add up fast)
   Flowmaster 40's
   no "pre-muff"/no resonator
   still not Kirk'd
----- Original Message ----- 
From: "van Oss" <vanOss@centurytel.net>
To: <shotimes@autox.team.net>
Sent: Tuesday, May 25, 2004 8:08 PM
Subject: [Shotimes] Gen2 door on a Gen1


> I have a 91 that needs a right front door immediately.  I just got a good
> door from a Gen2.
>
> I think I can sort out the minor wiring difference (one of the connectors
is
> different -- Gen1 has two conductors, Gen2 has four wires going into three
> terminals).  This is a winter driver so I don't care about having a Gen1
> mirror on the left and a Gen2 mirror on the right.  My questions are about
> the INSIDE door handle:
>
> -- It is not obvious how the Gen2 interior handle is attached to the sheet
> metal.  Anybody know?
>
> -- Might I be able to swap in the Gen1 handle (and maybe the linkage)?
>
> -- If I can't swap the handles, I could live with having one door with a
> Gen2 trim panel in an otherwise Gen1 interior.  Will I burn in hell?  I
can
> already hear Andy Angermeier saying "It's not stock!"
>
> Any advice welcome.
>
> VO
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes