[Shotimes] L0S PCM?
Adam Parrott
Adam Parrott" <parrotta@usa.net
Fri, 8 Oct 2004 18:46:42 -0500
Agreed with Jim and Mark. A TwEECer will not be able to correct or even
work around a physical (electrical) problem like a bad/bum driver (which is
most likely the cause of your secondaries problem with the L0S).
OTOH, a dead PCM also makes a fashionable paperweight. ;)
Adam
----- Original Message -----
From: "Jim and Debbie Leyden" <jndleyden@comcast.net>
To: "'Shotimes'" <shotimes@autox.team.net>
Sent: Friday, October 08, 2004 6:20 PM
Subject: RE: [Shotimes] L0S PCM?
Sounds like a hardware problem, most likely a blown output driver.
Make a good Frisbee!
Jim
-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of Ron Porter
Sent: Friday, October 08, 2004 2:13 AM
To: Shotimes
Subject: RE: [Shotimes] L0S PCM?
Can the twEECer board correct a bad circuit that runs the secondaries? This
PCM doesn't feed the 12v to the green wire at idle, it sits at about .7-.8v
all the time, not only after 4K like it's supposed to.
Ron Porter
-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of Mark Nunnally
Sent: Thursday, October 07, 2004 11:07 PM
To: shotimes@autox.team.net
Subject: Re: [Shotimes] L0S PCM?
91
with the twEECer board, you can run the X2J program on any year computer :)
mark
----- Original Message -----
From: "Ron Porter" <ronporter@prodigy.net>
To: "Shotimes" <shotimes@autox.team.net>
Sent: Thursday, October 07, 2004 11:03 PM
Subject: [Shotimes] L0S PCM?
> Anyone know what year MTX had the L0S PCM? I know it wasn't '89 (B9,
> or something like that), and not the later Gen 2s with the X2J.
>
> FWIW, I had bought a spare X2J from Justin Shick in the chance that
> was the problem with my inop secondaries. Well, turns out that was it.
> The car is now back to it's ass-kickin' BOS-equipped self.
>
> Anyway, I got a surprise when I wrestled out what I thought was the
> original X2J. Turned out to be a reman L0S. Original owner was doing the
> "dyno-tune via USPS" with Vadim when he installed the BOS back in the
> '90s, so I suspect this got swapped somewhere along the line.
>
> Ron Porter