[Shotimes] Rod bearing question

[Mike]

I'm a little puzzled as to the recommendation of some to replace the carrier
gasket.  Its not a wear item, and if its not leaking, leave it alone.  The
seal will come out easily whether the carrier is on or off the engine.
Don't ask for trouble.
Mike


----- Original Message ----- 
From: "David Nesbit" <bdnesbit@sc.rr.com>
To: "SHOTIMES" <Shotimes@autox.team.net>
Sent: Tuesday, September 07, 2004 8:11 PM
Subject: [Shotimes] Rod bearing question


> I am replacing my clutch.  The clutch itself was not to bad, but the
throwout
> bearing was toast.  While I am in there I chose to do the rear main seal
and
> carrier gasket.  I also decided to do the rod bearings as preventive
> maintenance. I assume that I have to remove the main bearing support
bracket
> to get access to the rod caps.  Is this correct? Also I was questioning
> whether or not I have to have the flywheel resurfaced.  It has some spots
on
> it(not pits) but is very smooth.  Will resurface be of any advantage?
> Thanks
> David  94ATX&91
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes