[Shotimes] Blend Door Motor

Ron & Dorathy DeReus dereus@dwx.com
Mon, 27 Sep 2004 07:33:03 -0500


That's good news, but there doesn't appear to be enough room to work under
the cowl to release the 3 press-fit connectors.

-----Original Message-----
From: shotimes-admin@autox.team.net
[mailto:shotimes-admin@autox.team.net]On Behalf Of Steve Weinrich
Sent: Monday, September 27, 2004 5:48 AM
To: Shotimes
Subject: Re: [Shotimes] Blend Door Motor


The BDA (Blend Door Actuator) replacement does not require the disconnection
of the coolant and A/C lines unless you ALSO plan on replacing the heater
core..

A ratcheting 8mm box wrench will come in handy.

Steve W



----- Original Message -----
From: "Ron & Dorathy DeReus" <dereus@dwx.com>
To: "Shotimes" <shotimes@autox.team.net>
Sent: Monday, September 27, 2004 12:25 AM
Subject: [Shotimes] Blend Door Motor


> Is there any way of changing the blend door motor without unhooking all
the
> a/c and coolant lines?
>
> All the emails saying this is  PITA job were being too nice.    I can see
> it, touch it, smell it, I want to be able to pass it through somebody's
> lower intestine by the end of the day tomorrow.
>
> Ron DeReus
> 95 MTX
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes