[Shotimes] Blend Door Motor

[Steve Weinrich]

Use the mentioned wrench to remove the BDA from the top of the plenum.

Steve


----- Original Message ----- 
From: "Ron & Dorathy DeReus" <dereus@dwx.com>
To: "Steve Weinrich" <stevwein@swbell.net>; "Shotimes"
<shotimes@autox.team.net>
Sent: Monday, September 27, 2004 7:33 AM
Subject: RE: [Shotimes] Blend Door Motor


> That's good news, but there doesn't appear to be enough room to work under
> the cowl to release the 3 press-fit connectors.
>
> -----Original Message-----
> From: shotimes-admin@autox.team.net
> [mailto:shotimes-admin@autox.team.net]On Behalf Of Steve Weinrich
> Sent: Monday, September 27, 2004 5:48 AM
> To: Shotimes
> Subject: Re: [Shotimes] Blend Door Motor
>
>
> The BDA (Blend Door Actuator) replacement does not require the
disconnection
> of the coolant and A/C lines unless you ALSO plan on replacing the heater
> core..
>
> A ratcheting 8mm box wrench will come in handy.
>
> Steve W
>
>
>
> ----- Original Message -----
> From: "Ron & Dorathy DeReus" <dereus@dwx.com>
> To: "Shotimes" <shotimes@autox.team.net>
> Sent: Monday, September 27, 2004 12:25 AM
> Subject: [Shotimes] Blend Door Motor
>
>
> > Is there any way of changing the blend door motor without unhooking all
> the
> > a/c and coolant lines?
> >
> > All the emails saying this is  PITA job were being too nice.    I can
see
> > it, touch it, smell it, I want to be able to pass it through somebody's
> > lower intestine by the end of the day tomorrow.
> >
> > Ron DeReus
> > 95 MTX
> > _______________________________________________
> > Shotimes mailing list
> > Shotimes@autox.team.net
> > http://www.team.net/mailman/listinfo/shotimes
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes