[Shotimes] good news!

[Ian Fisher]

When you replace the Shrader valve, make sure you
install new copper gaskets to make sure that it won't
leak. They are/were available from Ford.

Ian


--- "Hartberger, Jason M.  AT2 (AW)"
<hartbejm@cvn71.navy.mil> wrote:

> I finally got all the codes cleared. I've repaired
> all the wiring,
> replaced all the components I needed to, and I
> finally cleared that
> stupid MAF code. The car runs just as strong as it
> used to, maybe even
> stronger for the experience ;) (I'm sure I cleared
> some crap out of the
> engine running it so lean). I'd like to thank you
> all for the help and
> support you've given me over this week, I know I
> wouldn't have been able
> to get through it without you guys. I still need a
> Schrader valve for my
> fuel rail, so I'll be contacting one of you off-list
> to get that, but
> the leak is patched (hey, I was on the pipe-patching
> team on the repair
> locker) and I don't think it'll be an issue. Now if
> I can just stop
> running over curbs in parking lots! Man, that's
> harsh. Probably not good
> for the already-going wheel bearings, either :(
> 
>     V/R
> 
>     AT2(AW)Jason Hartberger
>     USS Theodore Roosevelt CVN-71
>     AIMD/IM-3/SHOP 8
>     CASS Tech/2M Tech
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
> 



		
____________________________________________________
Start your day with Yahoo! - make it your home page 
http://www.yahoo.com/r/hs