[Shotimes] Oil Filters and Remote Locations

[Beisler Jonathon]

Okay, but it there a kit that you use?  What do you place in the original filter location, etc?  I'm sure I could find this on the internet, but just wondering what others have used/are using.
Thanks,
JB

-----Original Message-----
From: Rich Bruso [mailto:shoguy_89@cox.net]
Sent: Friday, July 29, 2005 4:15 PM
To: Beisler Jonathon; dataflash@yahoo.com; Shotimes
Subject: Re: [Shotimes] Oil Filters and Remote Locations


> Now, secondly, are there procedural write ups on doing a remote filter
> location install with what's needed, etc?

   I don't know if anyone has published a procedure, but I ended up with a dual setup that I mounted outside the frame below the facotry outer air box location and in front of the splash shield.  I had to trim the splash shield a bit, and I put some excess hose on the outside of the lines to keep from cutting through the lines.  I could take some pictures if you'd like.
   My setup is a basic spin-on adapter and two lines running to a one piece dual filter mount.
   I have seen other setups with a single filter on the inside of the frame rail and one with it on the firewall, but IMO I'd rather have the filters out in the open and NOT blocking access to other parts.  Where they are on my car make oil changes a snap, and, in theory, two filters in parallel should flow more oil volume before opening the bypass valves.


-Rich Bruso
89 Black (Lola)
89 Silver (parts)
Sierra Vista, AZ