[Shotimes] methods to swap my engine
Ian Fisher
dataflash@yahoo.com
Thu, 9 Jun 2005 19:33:56 -0700 (PDT)
Hi
I was planning on swapping my engine by dropping the
subframe and pulling the trans (I need to swap
subframes anyway). So up until this point, I'd use an
engine support brace as if I was doing a clutch job
(if I can locate the shared NJ brace-Bill?). Now, I
assume I can attach the chains holding the motor to a
hoist, take up slack in the chain, remove the brace
and pull the motor?
What about installing the engine? It seems a bit
tricky to have to transfer the engine from the hoist
to an engine brace. I'm also working with limited
space if I do this in my driveway so I will need to
keep the hoist in front of the car which may interfere
with moving the subframe around, jackstands, etc. IOW,
I will probably need to reuse the brace for
installation so that I can move the hoist out of the
way to re-install the trans and subframe.. (I'm
feeling the pain in my back and arms just thinking
about this)
Ideas?
thanks
Ian
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com