[Shotimes] tensioner bearings

[Leigh Smith]

Sure.
The pulley housing is 15mm wide there, but so what. 1 pulley is wider than
the other anyway.You just need to be able to tighten everything down so the
adjustment doesn't slip.
I'll bet you can find a washer between 20 & 37 mm easy enough. I'd just
press the bearing into the pulley towards the back of the housing. The
current one fits flush, or almost, so a flat plate works on the press. For
this you might need an appropriate sized installation tool.  Like 36mm.
Recall the recent wheel bearing problem here on the list.
Lee

Lee

----- Original Message ----- 
From: "van Oss" <vanOss@centurytel.net>
To: <shotimes@autox.team.net>
Sent: Friday, June 10, 2005 8:12 PM
Subject: [Shotimes] tensioner bearings


> Okay, our tensioner bearings are ID 20mm, OD 37MM, width 15mm.
>
> It turns out to be no big deal on McMaster-Carr to find a sealed
> earing  --- even stainless --- that is 37mm OD and 20mm ID and 12mm
wide --- 
> 3mm narrower than our bearing.
>
> What's 3mm between friends?  Can't we make that up with a washer?
>
> VO
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes