[Shotimes] Quaife install question
Robert Bruce
rbruce@bellatlantic.net
Sat, 05 Nov 2005 17:44:39 -0500
I went back and measured the clearance a couple of more times. Got the same results each time. The .035" gap feels rather loose. A
.036" shim is definitely too tight. I received a few replies from various SHO community members (Thanks!). Ultimately I decided
that a .001" - .002" crush isn't the end of the world. It is far better than leaving the setup too loose. Since the one and only
shim I have (.037") will give these results, I went with it. At this point the tranny is completely rebuild with a Quaife, and
drilled & tapped for the new coolant pump and cooler.
With the afternoon free and the weather near perfect I decided to start removing the old tranny from the car. A few hours later and
the engine is hanging by a et of freshly built cradles. Sub frame is laying in the driveway. The old tranny is ready for removal
first thing tomorrow morning. Man this has been a SHO fun and productive day!
Now it's time to spend some quality time with the boss of the household.
Bob Bruce
92 w/ a mod or two
-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net] On Behalf Of Bob
Sent: Saturday, November 05, 2005 4:12 PM
To: shotimes@autox.team.net
Subject: RE: [Shotimes] Quaife install question
I would stick the shim to a block and thin it out using some 1000/1500 grit
wet/dry sandpaper taped to a piece of glass. You will need a micrometer,
but it sounds like you have one.
-- Bob
> -----Original Message-----
> From: shotimes-admin@autox.team.net
> [mailto:shotimes-admin@autox.team.net]On Behalf Of Robert Bruce
> Sent: Saturday, November 05, 2005 4:16 AM
> To: TechSHO@topica.com
> Cc: shotimes@autox.team.net
> Subject: [Shotimes] Quaife install question
>
>
> I am just completing a transmission rebuild and Quaife
> installation. I measure a .035" gap with my new differential and the Ford
> gauge tools. The old shim from this transmission is a .037".
> What size should I order/install? Can I safely use the .037 shim to
> get a .002" preload? Should I order a .035" shim for zero preload?
>
> Bob Bruce
> 92 w/ a mod or two
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes