[Shotimes] How to remove the oil level sensor???

[Edward Mazurek]

Hi,

Thanks for the help. I finally saw the clip and using a small screwdriver
from the inside, pryed it out of the slot. I could then remove it with
some plyers.

Thanks again!

Ed

clubairth@bellsouth.net wrote:

> Ed:
> The clip is internal to the holder screwed into the oil pan. Grab the 
> hard plastic sticking out of the holder and just pull straight back. 
> The hard plastic has a molded ridge on it that expands the metal clip 
> and then allows the metal wire to spring back holding the connector in 
> place as you push it in. It will pop out and be covered in oil because 
> it's below where the oil drips when you change the oil filter! Use a 
> bit of caution because this plastic is now brittle from heat and age. 
> Wiggle it a bit as you pull straight back.
> .
> .
>
>
>
>> Hi,
>>
>> I'm doing a bunch of maint to my 95mtx and I have the helms
>> manual. It says that there is a clip to be removed to get the
>> wire harness off the oil level sensor so I can remove the
>> oil pan. I don't see any clip???
>>
>> What's the trick??
>>
>> Thanks!
>>
>> Ed Mazurek