[Shotimes] Intermittent stalling after battery replacement?

Adam Phillips adambant@hotmail.com
Tue, 10 Jan 2006 21:42:48 -0500


I had some woes a few days ago after replaceing my battery. Just for kicks, 
check your DIS module, thing on the battery side of your intake. One of my 
connectors was ever so slightly unlatched, causing a no spark, and obviously 
no start/run conditon. Just somthing simple to check. I would also just go 
over all your connectors under the hood just to check for somthing simple 
you know? One other spot you might want to check, is where the positive 
cable meets your fuse box, up at the firewall, drivers side, make sure those 
connections are clean and tight, and any other connections and/or grounds. 
Also, do you know what those codes point to?



Adam Phillips
92 White MTX
135k, HID's
Tinted
Navigated
ALSFB's





>From: Peter Chase <pbchase@gmail.com>
>To: Sholist <shotimes@autox.team.net>
>Subject: [Shotimes] Intermittent stalling after battery replacement?
>Date: Tue, 10 Jan 2006 21:24:57 -0500
>
>Put in a new battery in my 92 MTX on Friday.  Today on the way to work (<5
>min drive this week) the car turned off and then back on again all in about
>a quarter of a second.  Then it did it again on the way home, and at the
>next stop light, it cut out completely and left me with a bright CE light.
>The car cranked over fine, but it didn't start.  I don't recollect if the 
>CE
>light was on while cranking, however.  I pulled the codes when I got home
>and had a  542 and a 538.   I let the car run for about 5 minutes to see if
>it would stall again, but nothing.  After reading about battery cable
>problems, I tried to wiggle both the pos and neg cables, and then even got
>under the car and wiggled the positive cable where it comes down to the
>starter to no avail.  Also, the SHotimes FAQ mentions a smaller wire for 
>the
>computer going into the positive connector, but my car has always had just
>has one thick wire going down to the starter.  Any ideas? Crankshaft 
>sensor?
>How much is the sensor and how many hours labor should I expect to pay?
>
>Peter
>_______________________________________________
>Shotimes mailing list
>Shotimes@autox.team.net
>http://www.team.net/mailman/listinfo/shotimes

_________________________________________________________________
Express yourself instantly with MSN Messenger! Download today - it's FREE! 
http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/