[Spridgets] 5 Speed Conversion problems

Pat pelliott at innercite.com
Sun Jul 13 18:09:54 MDT 2008


I had the same issues.  1961 mkII and radiator, 1275 with plastic fan..   If
you can put a steel fan on it's not as "deep" and will clear. Or go with a
later cross-flow radiator. Also not as thick..  Once you drive behind that
5-speed, you'll never want to go back.

-----Original Message-----
From: spridgets-bounces+pelliott=innercite.com at autox.team.net
[mailto:spridgets-bounces+pelliott=innercite.com at autox.team.net] On Behalf
Of Mike Rivers
Sent: Saturday, July 12, 2008 9:40 PM
To: spridgets at autox.team.net
Subject: [Spridgets] 5 Speed Conversion problems

Hi,

I am encountering major problems with a Datsun 5 Speed kit I have recently
received.  Although the adapter plate fits excellent, the rear trans mount
is too high and will not allow rear movement.  Due to this, the fan hits the
radiator. I already had to bash the heck out of the bottom of the heater
duct and the top of the transmission tunnel to just get it to fit and so the
driveshaft wouldn't hit.  Will an earlier fan/pulley work better since I
have the 1275 plastic fan/cast iron pulley type?

Suggestions?  Ditch the kit and reinstall the original 4 speed ribcase?

Mike Rivers
1961 MG Midget 1275
You are subscribed as pelliott at innercite.com

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets


More information about the Spridgets mailing list