[Spridgets] Hex Size

rrengineer @dslextreme.com rrengineer at dslextreme.com
Mon Mar 9 17:58:10 MST 2009


Alright, even if I did figure out a way to cut out a one time use wrench, I
still don't know the distance across flats of the hex nut.  So, back to my
original question, what size is the hex nut?  One more question.  I read in
Paul's installation instructions that a 10mm washer goes below the hex nut
for "take up".  If there was one there, I don't see it anywhere in the trans
tunnel near the angle drive.  Do any of you remember using this washer in
your installation and is it absolutely necessary?
Mike

On Mon, Mar 9, 2009 at 5:46 PM, Frank <spritenut at comcast.net> wrote:

> rrengineer @dslextreme.com wrote:
>
>> Glen,
>>     I don't have any way to cut 1/8th steel.
>>
> Angle grinder with a metal cut off blade. (not a grinder wheel but a thin
> metal cutting wheel)
>
>


More information about the Spridgets mailing list