[Spridgets] SU Needle question

Linda Grunthaner grunthaner at gmail.com
Mon Mar 23 10:27:08 MST 2009


Thanks Bill,As it turns out I was missing one of my dash pot screws I ether
didn't tighten it and it vibrated out or I forgot to put it back in. She
runs a lot better now but I still need to make some adjustments. Time to
crack the books.
Lin

On Sat, Mar 21, 2009 at 10:29 AM, <corvallis at peoplepc.com> wrote:

> Lots of different SU needles. There can be a letter id stamped on the large
> end. Also, the needle works in the fuel tube orifice, which can also be
> worn
> by previous needles being off-center ...and ages of fuel flow. Some people
> replace these in matching sets to avoid wear problems that can't be easily
> seen. There are some very good booklets related to SU's that explain this,
> and tune up. ...bill
>
> ===========================================================
> -----Original Message-----
> From: spridgets-bounces at autox.team.net
> [mailto:spridgets-bounces at autox.team.net] On Behalf Of Linda Grunthaner
> Sent: Saturday, March 21, 2009 7:16 AM
> To: Spridgets
> Subject: [Spridgets] SU Needle question
>
> I just got to thinking after looking at this site below on SU Needles (link
> on lower right) that before start buying lots of stuff for my ill starting
> &
> running 1275 I should replace the needles because I used an old one I had
> and even though they look clean they could be damaged right? Or am I wrong
> on that? I don't understand if this link refers to Spridgets or big Healeys
> but it just had me thinking.
>
> Lin
>
> http://pages.sbcglobal.net/jbcarey/index.html
> _______________________________________________
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as grunthaner at gmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets


More information about the Spridgets mailing list