[Spridgets] [midgetsprite] Smith heater blower impeller removal
Cebridge
60bugeye at cebridge.net
Sun Jun 21 11:53:33 MDT 2015
Grind the pins on the pliers smaller on a bench grinder lol
Leo
> On Jun 21, 2015, at 12:51 PM, Walt Swift wlswift at yahoo.com [midgetsprite] <midgetsprite at yahoogroups.com> wrote:
>
> I'm refurbishing a Smith heater blower - probably from a Mark III or IV Sprite. The plastic impeller is attached t the shaft by means of a plastic "compression" fitting held in compression by a spring ring.
>
> Is there a specific tool that works for removing the spring ring? Or do I have to make one? It would be similar to a snap ring removal tool. Tried a small one, but the tool pins are not small enough to fit into the spring ring gap.
>
> Anybody solved this one?
>
> It's Father's Day and I'm in the mood for buying myself another tool!
>
> Walt
>
> 60 Bugeye - 90% of the way to being 95% complete
> __._,_.___
> Posted by: Walt Swift <wlswift at yahoo.com>
> Reply via web post • Reply to sender • Reply to group • Start a New Topic • Messages in this topic (1)
> VISIT YOUR GROUP
> • Privacy • Unsubscribe • Terms of Use
> .
>
>
> __,_._,___
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20150621/f0f5b77f/attachment.html>
More information about the Spridgets
mailing list