[Spridgets] Question about mating the transmission to the engine

[Rick Fisk]

David,

They should go together fairly easily.  If you're against a hard stop something is amiss.  I wouldn't force it.  Pull the trans back off and see what's going on.  There are different pilot bushes, but the ID should be the same on all of them.

Rick
Sent from my keyboard

> On May 17, 2016, at 1:03 AM, David Ambrose via Spridgets <spridgets at autox.team.net> wrote:
> 
> 
> We're trying to mate a new transmission to a 1275 engine. After a two attempts at assembling the clutch using the clutch pilot, we were able to mostly mate the transmission to the engine. There's about 3/8 inch left. The transmission isn't going on easily and I'm wondering if we should use the bell housing bolts to pull them together or take is all apart again, and make another try.
> 
> This is a replacement transmission of unknown parentage other than it came out of a Midget. I was wondering if the pilot bushing might be a different diameter. Were there multiple sizes?
> 
> Thanks,
> Dave Ambrose
> 
> 
> ------------------------
> 
> spridgets at autox.team.net
> 
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
> 
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/refisk@chartermi.net