[Spridgets] Bottom seal for spindle hub to kingpin
Michael MacLean
rrengineer.mike at att.net
Sun Feb 4 08:48:42 MST 2018
Frank's hose washer solution was to replace the two cork washers either side of the kingpin to seal the grease in the fulcrum pin. The seal I am talking about sits 90 degrees from those under the kingpin bronze bushing. I believe today's rebuild kits use a rubber o-ring to seal the grease in the kingpin and the thrust washer does this at the top. Just need to know what size o-ring.Mike MacLean
Sent from Yahoo Mail on Android
On Sun, Feb 4, 2018 at 4:24 AM, Hal Faulkner via Spridgets<spridgets at autox.team.net> wrote: ------------------------
spridgets at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation: $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/rrengineer.mike@att.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20180204/a4676660/attachment-0001.html>
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: Untitled
URL: <http://autox.team.net/pipermail/spridgets/attachments/20180204/a4676660/attachment-0001.ksh>
More information about the Spridgets
mailing list